Select Page

MANTA5 F.A.Q.

HYDROFOILER

Can the Hydrofoiler handle chop and swell?

You can ride on oceans, rivers and lakes, handling moderate chop and swell. The front tiller section of the Hydrofoiler self-levels and help to punch through chop and over swell as you ride.

Always ride to your ability and practice caution in riskier conditions.

Who can ride the bike?

Confident swimmers between 130lbs – 220lbs (60-100kgs) of any age, no license required. The Hydrofoiler is optimised for riders weighing between 155lbs-200lbs. To perform the submerged launch, riders do need to weigh below 220lbs in order to re-surface. 

How fast does the Hydrofoiler go?

The bike boasts a top speed of 13mph (22km/h) and a cruising speed between 7 – 8mph (11–13km/h). Minimum speed needed to foil is 5.2mph (8.5km/h) – less than 5 knots.

How long does the battery last?

The battery offers up to 4 hours of riding time on the lowest assist level and 1.5 hours on maximum assist*. Riding conditions, rider input and ability will affect ride time. The 70 cell lithium-ion battery pack delivers 22Ah with each battery pack being easy to swap out in minutes.

To recharge the battery, the battery plugs into any standard wall socket and takes 3 hours to charge back to full.

* Ride duration is subject to rider weight, water conditions and level of electronic assistance the rider has selected.

How does the battery handle the heat/cold?

The total ride time (battery life) may differ when operating in extreme ambient temperatures.  

For example, all lithium batteries achieve optimum service life if used at 68ºF (20°C) or slightly below. If, for example, a battery operates at 86ºF (30°C) instead of a more moderate lower room temperature, the cycle life is reduced by ~20 percent.

How do I transport the Hydrofoiler?

The Hydrofoiler™ XE-1 is the most mobile personal watercraft in the market today. Designed to be broken down into three parts; front foil, rear foil, and body. This allows for simple storage and transportation in-car or on roof racks. The Hydrofoiler can be assembled within 5 minutes and carried to the water by hand. 

What is the Hydrofoiler constructed from?

Strengthened carbon fibre which is set with high performance epoxies (front and rear hydrofoils). Aircraft-grade, TIG-welded 606-T6 aluminium (frame). Vacuum-formed ASA plastic (buoyancy modules).

How big is the Hydrofoiler (weight/dimensions)?

The Hydrofoiler™ XE-1 currently weighs 67lbs (30.5kgs) including battery and motor.

Fully assembled bike dimensions: 4,5ft High x 6,5ft Wide x 7,2ft Long (1.4m High x 2m Wide x 2.2m Long)

What riding gear would I need?

Manta5 insist that riders wear a personal flotation device (PFD)/life jacket and carry a communication device. The PFD will help the rider float in the water when they’re not riding. The communication device is to contact someone on shore in the case of an emergency.

 

* Manta5 recommends that riders also check and abide by local policies and regulations when riding.

How does the Hydrofoiler get serviced?

All Hydrofoiler XE-1’s are serviced by Manta5 authorised service agents, with some components able to be self-serviced with sufficient skill and experience. Customers will have access to a list of service agents in their area through the Distributor Locator page on our website.

Most of the XE-1 componentry is constructed from standard bicycle parts and can be serviced through your local bicycle service center. Repairs to the battery and motor, however, must be completed at the Manta5 HQ or an authorised service agent.

What is the minimum water depth required to foil and submerged launch the Hydrofoiler?

A minimum depth of 3ft (1m) to ride the bike in, is recommended. However, to perform the submerged launch to resurface this would require a minimum water depth of 7ft (2m).

What happens when I stop pedalling?

The bike floats on its side when stationary. When you stop pedalling you will slowly sink down into the water. Buoyancy prevents the bike from sinking when you stop pedalling. Master the remounting technique to perform a “submerged launch” to get foiling again from deep water.

SHIPPING

How much does shipping and delivery cost?

All Hydrofoiler XE-1’s are packed and delivered to your preferred shipping address. Orders will be shipped in order of reservation number.

 

  • United States: starting from $495 USD to contiguous United States; $750 USD per bike to Hawaii; $1,000 USD per bike to Alaska
  • Europe/UK: starting from €420 EUR*
  • New Zealand: $125 NZD per bike

* Switzerland customers will pay an additional €33,75 per bike for T1 documentation fee.

Taxes (incl. VAT) are not included in the shipping cost. Subject to state and local taxes. Customs and handling fees are included in the shipping price.

WARRANTY

How long does my warranty last for?

All Hydrofoiler­ XE-1’s come with a comprehensive replacement warranty for all XE-1 components and frame. To read more about the warranty, please click here.

What are the terms and conditions of sale?

To read more about the terms and conditions of sale, please click here.

0
    Your Cart
    Your cart is emptyReturn to Shop